• ldai3

1. Tie design.
Jacquard neck ties: design or think out the pattern to have a certain regularity, then use the tie design special software, according to the pattern design can be used on the fabric loom software or flower version.
Printed ties: there are no specific rules for the pattern, as long as you can think of it, it can be printed on, printing must first do a good film, which is usually called film, and then made into a flower version.


2. Tie fabric.
Jacquard woven ties: it is made of dyed silk woven by machine, so the fabric looks more three-dimensional.
Printed ties: It is made of white embryonic fabric and printed with pigment, which is softer to the touch and more colourful.


3. Tie Cutting.
First of all, the fabric should be cut into the shape of the tie, note that it must be cut at an angle of 45 degrees. The fabric determines the length of the tie. Then, the lining of the tie must be cut, usually with polyester, silk or wool. The shape of the tie will be based on the lining, generally divided into straight, small bottle type, large bottle type, depending on personal preferences. Lastly, the silk lining of the tie (which is the fabric on the reverse side of the tie) is usually used to make the brand mark on some ties, but nowadays it is common to use a regular fine point silk lining. In order to reflect the grade of the tie, some use the same fabric as the tie to do the silk lining, so the cost of the fabric is very different.


4. Workers processing tie forming steps.
With a flat car connected to the fabric, and then the silk lining with the fabric, and then into the lining, ironing workers to wrap the fabric lining, sewing workers with a needle to the tie fabric and inside the lining sewn together (that is, a line in the middle of the reverse side of the tie), in the steam ironing the tie flat, forming.

Post time: Jan-27-2022